top of page

Signs Your Pool Pump Needs Repair or Replacement

Have you noticed that your pool seems to be getting dirty every day? If this is happening to your pool, that’s a sign you have a pool pump problem. It’s best that you hire a pool pump repair service ASAP to address this issue. The pump is the heart of the pool’s plumbing system. It creates the water flow that makes the chemicals circulate evenly throughout the pool and to the filter, chlorinator and heater. The pump increases the effectiveness of the pool chemicals that fight bacteria and algae in the water, keeping it sanitized and clean. It it vital to have regular pool service in Charlotte NC or in another area that you live. This will ensure that your pool stays in optimal working shape.

Here is what you need to do to recognize when it’s time to call your trusted pool service experts. These are some common signs that your pool pump needs replacement or repair.


Pool pump leaks are a serious problem because they can burn out the pool pump motor. They can be caused by a malfunctioning shaft seal, thread sealant, an impeller or the pipe that comes out of the pump.

If your motor shaft gets damaged, you may notice water on the floor around the pump. A leak in the pressure side of the pump will cause a drop in water pressure and a water loss. Water spraying from the pump housing is a sign the pump seal is broken.

To avoid that your pool pump become compromised, when you spot a leak, contact a company that provides pool service Charlotte NC or another area near you.

Air Leaks

Small air leaks are very common and harmless, however, when the air leak gets too large, it can interfere with the water circulation and cause the pump to lose its prime. An air leak is usually caused by a leaky valve stem on a suction valve, a break in the plumbing, or a damaged thread sealant.

Low water level

The pump’s impeller is responsible for pushing water through the plumbing system. One of the reasons for a low water level is a worn or clogged pump impeller. The low water level can cause excess air in your pool pump and filter. If the pump continues pushing air instead of water, it will soon overheat and burn out. Inspect the impeller to determine if it is worn or clogged. Clean out the debris immediately if it is clogged.

Loud noise

A loud pump is definitely not something that you or your neighbors enjoy during a day relaxing by the pool. If your pump is making noise, you should listen to it to determine if the sound is coming from the motor or the wet end of the pump. If you hear a loud screech or grinding, your pump may need new bearings.

It often sounds like there are small rocks in the pump. Vibrations along the base of the pump or cavitation may be the culprit. Cavitation happens when the pump can’t get sufficient water fast enough, causing the pump to run dry and lose its prime over time. Sometimes debris can get pulled into the pump, so you should also look for internal blockage and clear out any obstructions.


One of the main reasons that a pool pump can stop working efficiently is the age of the pump motor. Its average lifespan is approximately 7-10 years. If your pump is approaching this age, you may face frequent repairs and breakdowns. In this case, it’s better to buy a new one than wait till the cost of maintenance outweighs the value of the old pump.

Whether it’s the pool pump or murky water that’s been troubling or you need pool and spa maintenance in Charlotte NC and the surrounding areas, contact Pink Flamingo Pool Company, your trusted pool service and repair service company. Our knowledgeable and well-trained technicians provide unparalleled pool service in Charlotte. If you’re looking for the best pool service Charlotte NC, call us today at 704-957-0038 or contact us online.

59 views0 comments

Recent Posts

See All


bottom of page